Top 10 Best Bearing Heater

Non-Electric Heat On-the-Go Maximize heat output wherever you are with this 10,000 BTU indoor kerosene heater that boasts a heating zone of up to 380 square feet. Large Capacity Tank Fill the 1.2-gallon tank once to stay warm for up to 14 hours and enjoy your kerosene shop heater for an extended time without worrying too much. Heater Kerosene Safety Features Automatic shut-off mechanism and a push-button start make it easy to light the kerosene garage heater without matches or electricity. Non-Electric Heater Intuitive Features Offers EZ Flame adjuster, tip-over switch, and protective safety grills to avoid any potential danger while using the kerosene radiant heater. Kerosene Heater Indoor and Outdoor Use Safe for garages, poorly insulated rooms, and other hard-to-heat spaces, this portable kerosene heater is convenient and user-friendly at the same time.

Economic alternative to magnetic induction units. Safer than heating bearings with oil baths or torch. A good choice for those whith only an occasional need to heat a bearing. Light weight and portable, easy to move around shop or factory floor. No special wiring or set up, uses standard wall plugs 120V15A. Heats bearings up to an 8 inch 203mm inside diameter. Maximum weight of bearing for cone heater is 12 Lbs 5.5Kg.

Economic alternative to magnetic induction units. Safer than heating bearings with oil baths or torch. A good choice for those whith only an occasional need to heat a bearing. Light weight and portable, easy to move around shop or factory floor. No special wiring or set up, uses standard wall plugs 120V15A. Heats bearings up to an 8 inch 203mm inside diameter. Maximum weight of bearing for cone heater is 12 Lbs 5.5Kg.

PVC BENDING MADE EASY - Uniquely designed for quick precise heating of PVC conduit in the workplace. EVEN HEATING - Highly reflective interior provides even consistent heating. COMMANDING HEATING CAPACITY - 120 vac 2300 watts and 20 amps. USER FRIENDLY - Comes standard with a full-length door allowing for easy loading and removal of PVC conduit. MADE IN THE USA - This Current Tools product is 100 designed and manufactured in the United States of America.

Thermally protected. UL recognized. Clockwise shaft end rotation. 115 VAC model. Shaft measures 12 diameter by 2-12 length.

Aluminum housing. Thermostat range adjustable from 0 F to 100 F -18 C to 38 C. Four 10-32 x self-tapping screws are included with each heater. Ball bearing fan. Terminal strip with clamp connector that accepts both solid and stranded wire.

Single or three phase flexibility, available from 208 to 480-volt. Uniform air distribution evenly fills a large room. Overheat protected motor permanently lubricated, totally enclosed, heavy duty bearing. Long lasting, high efficiency heating element. Overheat protected motor, permanently lubricated, totally enclosed, heavy duty bearing.

Thermally protected. UL recognized. Clockwise shaft end rotation. 115 VAC model. Shaft measures 38 diameter by 2-38 length.

Thermally protected. UL recognized. Models shown with bases have 3-12 shaft height. 115 VAC model. Shaft measures 38 diameter by 2-12 length. 115 Volts, 1050RPM, 2.3 Amps, 115 HP, Rotation CW. Single Speed. 1 Year Manufacturer Warranty. Genuine Fasco Product.

Aluminum housing. Thermostat range adjustable from 0 F to 100 F -18 C to 38 C. Four 10-32 x self-tapping screws are included with each heater. Ball bearing fan. Terminal strip with clamp connector that accepts both solid and stranded wire.

MAINTENANCE PRODUCTS. Portable induction heater - 110v. Innovative heating of bearings. Portable, compact and lightweight. No support yokes required.