Top 10 Best Low Amp Clamp

60A ACDC Amp Clamp Probe. Use with most DMM. ZeroCalibration Function. 2-year warranty.

1mA Resolution Delivers 1mA ACDC resolution and sensitivity, which make it a great a tool for measuring such as parasitic draws.. Dual Line Display Dual line display can show both AC voltagecurrent and frequency or Celsius and Fahrenheit on the screen.. Low Impedance Mode Low Impedance LoZ mode for identifying and eliminating ghost or stray voltages.. Activate V-Alert at Any Function V-Alert function can be activated at any function not only greatly enhance testing experience, but also let you not worry voltage detector consumes too much space.. Probe Holder Side probe holder make measurement more convenient, especially for narrow or tight space environment..

Accurate measurements down to 1 mA .001A - 80A maximum reading DCAC. Larger clamp size of .75 19 millimeter and improved zero drift stability - Electronic Specialties enlarged the clamp opening as much as possible while still maintaining 1 mA resolution. MinimumMaximum and Peak MinimumMaximum functions, Data Hold, Relative Zero - Full DMM built-in. Built-in Temperature F C - Temp probe included. Measures DCAC Amps, DCAC Volts, Resistance, Capacitance, Frequency Hz and Temperature.

Automatic volt to amp conversion with N2 Neuron. Reads down to 10ma. Reads up to 80 A. 1 Year warranty. 12 Jaw size.

ACDC current measurement from 0.001 up to 100 A. which makes it a great tool for measuring parasitic draws and ACDC voltage measurement up to 600 volt. Small jaw 1.2 inches W x 0.53 inches D 300x13.4millimeters with clamp opening up to 12 inch 12.5 millimeters. Peak and Data hold functions with one rotary switch operation. 2 readings per second sampling and continuity check with audible indicator. Test leads soft carrying deluxe pouch and batteries included.

Digital clamp meter measures alternating current AC or direct current DC to 40 amp. Average-sensing meter provides accurate readings when measuring linear loads, where the current or voltage has a sinusoidal waveform. Hall effect clamp with 0.78 28 mm jaw opening measures current without touching or interrupting the circuit. Zero adjust function compensates for changes in output voltage due to environmental conditions. Meets International Electrotechnical Commission IEC safety standard 61010 and is certified for category III installations up to 300V.

Measures current range 0-60 ampere ACDC. Works for ignition coils, fuel injectors, relays, electric motors and parasitic draw. The ACDC current measurement is non-intrusive.

Compatible with many lab scopes and graphing multimeters. Use to generate current waveforms for diagnostic analysis. Also works great with digital multimeters. Jaw opening of 12 inch clamps over most negative battery cables. Low battery indication, auto power-off.

The product is highly durable. The product is easy to use. Manufactured in China. Heating elements are durable and are threaded for easy replacement. Activation Flow - 0.3 GPM.

1mA Sensitivity 1mA sensitivity when measures ACDC current by clamp.. Dual Line Display Dual line display can show both AC voltagecurrent and frequency or Celsius and Fahrenheit on the screen.. Low Impedance Mode Low Impedance LoZ mode for identifying and eliminating ghost or stray voltages.. Activate V-Alert at Any Function Activate V-Alert non-contact voltage detection function under any function design makes non-contact voltage testing more convenient.. Back Clip Design Back clip design make it more portable, hang on your belt or pocket..