Top 10 Best Marine Battery Switch

Selector 4 Position. Switches isolated battery banks to all loads or combines battery banks to all loads. Ignition protectedsafe for installation aboard gasoline powered boats. IP66 waterproof, ISO 8846 and meets ABYC requirements. Terminal Stud Size 38 - 16. Continuous rating 350A, Maximum voltage 32V DC.

Blue Sea Systems Battery Switch m-Series ONOFF with Knob, part number 6006, is a Single Circuit ON-OFF switch. Switches a single battery to a single load group. IP66 waterproof, ISO 8846 and meets ABYC requirements. Ignition protectedsafe for installation aboard gasoline powered boats. Make before break contact design allows switching between battery banks without power interruption. Continuous Rating 300A, Maximum Voltage 48V DC. Robust redesign done in July 2017. Premium warranty support.

Permits selection between batteries for starting, charging or operation in parallel. For use with two or more batteries and systems under 50V. UL listed, ignition protected and CE approved. Capacity 250A continuous, 360A intermittent. Size 5-14 inch x 2-58 inch. Manufacturer part number 50-11501.

For use with 12, 24 and 32 Volt Marine Electrical Systems. Capacity - 250 AMPS Continuous, 360 AMPS Intermittent. Ignition Protected. Built with quality materials.

Heavy Duty ABS plastic housing, durable made for safety use, rear cover insulates terminals against any short of circuits, equipped with 4 sets of bolts.. Operation OnOff 2 positions, 275 A continuous at DC 12V, 455 A intermittent at DC 12V, 1250 A momentary at DC 12V.. Compatible used for DC 12 - 48V systems to isolate and secure the electrical system, can stand alone or be locked together with other switch.Its purpose is to eliminate any power draw from the battery when vehicle or boat is not in use, disconnects the battery safely.. Widely used for car, marine boat, RV, camper, travel trailer, truck, ATV, UTV, battery banks and other devices.. Package include1x OnOff battery switch,4 bolts incuded..

Don't get stranded - Add a Battery. Combination of part number 7610 and 5511e. Amperage 120 Amps.

Practical power switch can be used to disconnect the battery from vehicle or boat when not in use to ensure safety.. Durable use compact size, slim modern look, robust and durable.install hole size29mm.. 32 V 100 A 100 A battery switch, strong load capacity with 150 amps intermittent, 100 amps continuous at a maximum of 32 V DC.. Plug and play easy to install and use, note the cover of this switch cannot be removed.. Installation universal for cars, off-road vehicles, trucks, motorcycles, boats, vans, etc..

Simple OperationSwitch on Power Switch off No power.Rating 275A DC Continuous 1hr, 455A DC Intermittent 5 min, 1250A DC Cranking 10 sec Stud Size 2x38 10mm. Durable Material This battery disconnect switch is made of ABS plastic housing, tinned copper studs and nuts.Come with 4 stainless steel mounting screws and caps to help fix the switch tightly. 4 Removable side plates provide access for battery cables. Safety Protectionbattery shut off switch can disconnects the battery safely, protect batteries from excessive drain when vehicle or boat is not in use. Great CompatibilityThis battery quick disconnect is used for DC 12 - 48V systems to isolate and secure the electrical system,and can stand alone or be locked together with other switch, simple and economical way to separate batteries.. Wide Applicationuniversal used not only for Car, Van, Caravan, RV, Truck, Marine Boat, but also electrical equipment's switch, such as flashing light, chassis light, fog light, dome light..

Heavy Duty ABS plastic housing, durable made for safety use, rear cover insulates terminals against any short of circuits, equiped with 4 sets of bolts.. Operation OnOff 2 positions, 275 A continuous at DC 12V, 455 A intermittent at DC 12V, 1250 A momentary at DC 12V.. Compatible used for DC 12 - 48 V systems to isolate and secure the electrical system, can stand alone or be locked together with other switch.. Purpose eliminate any power draw from the battery when vehicle or boat is not in use, disconnects the battery safely.. Copper terminal stud size 38 10 mm x 2, very easy to install, universal used for car, vehicle, Rv and boat, also electrical equipment's switch..

Versatile use for 6-volt to 32-volt D. C. direct current systems. Rated for 300 amps continuous use at 6 volts and 150 amps continuous use at 12 volts. Includes an automatic alternator field circuit disconnect to prevent surges and so, protect your valuable boat electronics. Rugged build features Bakelite housing, copper washers, and solid brass terminals and nuts. Attwood products are both compatible and reliable, engineered and built with a never-fail attitude. Sport type Boating.