Top 10 Best Taramps 800x4

EQUALIZER AND VOLTAGE an output voltage of 7V RMS at 0.05 THD 11V-15V and an operating voltage of 11V-15V. It also has a bass equalizer, mid-bass equalizer, mid equalizer, high equalizer and each frequency adjustable has a -12dB to 12dB. RCA INPUTOUTPUT Our 7-band parametric equalizer has a turntable input, pre-amp line aux inputs via RCA jacks, and an RCA line output for powered speakers. You may use the RCA output to connect a power amplifier, then connect the passive speakers. POWERFULLY IMMERSIVE AUDIO Take your audio to the next level with our 7 bands parametric equalizer creating an audio experience that lets you listen to your beats. Filling the room with blue light that burst through the speakers. PARAMETRIC EQUALIZER DIMENSIONS our product has a dimension of 7'' x 4.1''x 1.10'' -inches with an approximate weight of 1.5 lbs. It was a 7 volt RMS pre-amp output with 3 input sources selectable and it is in the size of half din. WHAT YOU GET You will receive 2 mounting brackets, 8 Phillips-head screws, and a power red wire with 1A fuse and pre-amp line aux inputs via RCA phone jacks when you purchase our 7 band parametric equalizer.

INPUT Inputs of signals to be amplified. Connect these signals to RCA outputs of Head Unit, using good quality shielded cables to avoid noise interference.. LEVEL It sets the amplifier input sensitivity, which allows an optimal adjustment to the output signals levels of nearly all models of Head Units found in the market. POWER Power Supply ConnectorThe connector terminal must be connected to the battery's positive pole with a 10mm minimum wire gauge. The connector terminal - must be properly connect to the battery's negative pole with a same wire gauge. The remote terminal must be connected to the Head Unit REMOTE output with a 0.75mm wire. WIRE HIGH LEVEL INPUT Input for high level low impedance signals from the speaker output of the players or multimedia center..

800 Watts RMS. 4 channels. 2 ohms stable. Compact design. Full range.

Two Ohm Per Channel Four Channel Car Audio Amplifier. Max Output Power 12.6 VDC - 2 OHMS 800W RMS 4 x 200W RMS. 12.6 VDC - 8 OHMS 242W RMS 4 x 60W RMS. Swichable L.P.F Low Pass Filter Fixed 80Hz -12dBoctave. Switchable Crossover High Pass HPF 80Hz -12dB8. Frequency Response Full Range 20Hz to 36kHz -1dB. Protection System Short into Output Power Supply HighLow.

INPUTInputs of signals to be amplified. Connect these signals to RCA outputs of CDDVD Player, using good quality shielded cables to avoid noise interference. LEVEL It sets the amplifier input sensitivity, which allows an optimal adjustment to the output signals levels of nearly all models of CDDVD Players found in the market.. HPF - HIGH PASSVariable adjustment from 80Hz to 2.2KHz, which determines the beginning of the amplifier operating frequency. OUTPUT To connect the speakers. Follow the polarity and the minimum impedance recommended. For STEREO connections, the minimum impedance is 2 ohms at each channel for BRIGDED connections is 4 ohms.. POWER Power Supply ConnectorThe connector terminal must be connected to the battery's positive pole with a 7 AWG wire gauge. The connector terminal - must be properly connect to the battery's negative pole with a same wire gauge. The remote terminal must be connected to the CDDVD Player REMOTE output with a 18 AWGwire..

1 x Taramps TS400X4 Full Range Amplifier. Quantity 1 Amplifier Number of Channels 04 Max Power at 13.8 VDC 2 Ohms 400W 4 x 100W RMS Max Power at 13.8 VDC 4 Ohms 252W 4 x 63W RMS Bridged at 13.8 VDC 4 Ohms 400W 2 x 200W RMS. Input Sensitivity 200mV VolMax Signal to Noise Ratio greater than 90dB Frequency Response Full Range 18Hz to 30kHz -3dB High Pass Crossover HPF 90Hz -12dB 8th Low Pass Crossover LPF 90Hz -12dB 8th. Input Impedance 22K Ohms Thermal Protection System and Short Output Minimum Supply Voltage 8 VDC Maximum Supply Voltage 16 VDC. Standby Power 0.8 A Maximum Musical Power at 13.8VDC 16.5 A Maximum Consumption in Sine Signal 1kHz 13.8VDC 33 A.

Excellent for voice as well as bass. 2 ohms. 800 watts. 4 channels. Bass boost.

Quality - This Class D 4 channel amplifier exhibits quality frequency response rates and crossover network which places this amp at a prominent place. Durable design and highly efficient performance makes this subwoofer amp for car speakers stand out amongst the others.. Power This Class D 1200 Watt RMS Car Amplifier has a power rating distribution as followed 300x4 2 Ohms, 192x4 4 Ohms. The 4 channel amplifier for car speakers also provides a 2-way protection circuitry as a part of its design.. Crossovers- The Taramps Multichannel Car Amplifier offers you the ease of connectivity by providing the feature of crossover. The 2 channel car amplifier provides you with options of fixed 90Hz Highpass Lowpass crossovers.. Features The 4 channel bass boost car amplifier has features like - Frequency Response 9Hz-27KHZ, Bass Boost, SNR88DB, Remote Bass Knob, 2-way protection, hilow pass crossovers and 2 Ohm Stable. Includes - 1 Taramps 1200W RMS 4 Channel Class D Amplifier.

Full-range. Class-D amplifier. 4 channels of 110 watts RMS 2 Ohms. Crossover HPF and LPF. Variable gain control.

It has 4 kennels of 500 watts RMS each. Its frequency respoosta is from 8Hz to 20 KHz to -3dB. Supply voltage between 9 and 17 VDC. Operation class D.

Full-range. Class-D amplifier. Crossover HPF and LPF. Frequency Response 10Hz 20KHz. 1 channel of 1200 watts RMS 1 Ohms.